500W 6 and 4 m linear amplifier with output filter built in
FOR 6 and 4 m. This is a classical design 500-600 W min. Of a push-pull Mosfet linear amplifier. 10-15W in will drive the amp to more than 600W output.
A small attenuation pad is provided for mosfet protection from over drive! Drive power at 50ohm=up to 15W. Built on heavy heat sink with best components. Output transformer is of the transmission line type with special Raychem 25 ohm coax line.This amp is a plug and play in an enclosure with all control and rx/tx relays and so239's or type "N". Special interface for PTT for minimal load on radio. AMP INCLUDES AN OUTPUT FILTER!! A great companion for 50-70MHz operation. I will supply all technical information and do my best to support your project.
Please feel free to write with your questions, I will be happy to answer and help! Please verify your address during checkout. Items will be checked carefully before sent out.
This Amp Is for Ham Use Only not intended for CB Or any radio with certain regulations And rules that tell you it is prohibited. The item "500W 6 and 4 m linear amplifier with output filter built in" is in sale since Wednesday, September 21, 2016.This item is in the category "Consumer Electronics\Radio Communication\Ham, Amateur Radio\Ham Radio Amplifiers". The seller is "4z4rb" and is located in ISRAEL. This item can be shipped worldwide.
- Brand: 4z4rb
- Model: 6 n 4
- MPN: 6 n4 amp
Output Power: 600W